JUST HOW TO RESET THE OIL CHANGE LIGHT IN A CAR

Just how to Reset the Oil Change Light in a Car

Just how to Reset the Oil Change Light in a Car

Blog Article



Has the "Maintenance" or "Oil Change" indicator light appeared on your vehicle? Learn what it means and ways to get it to show off.

Modern vehicles are designed with several indicator lights to owners when something needs attention, and the oil change light (also called the maintenance light) is one of them. This light is designed to let you know when the engine oil needs changing, on the basis of the car's odometer reading. The oil change light won't turn fully off alone, even once the old oil has been drained and fresh oil added. That's where resetting the oil change light comes in.

Not all vehicles have a fat change light, but when yours does, resetting it's worth doing, and not just because of the annoyance of seeing the light on constantly. Unless the light is reset, your automobile can have no method of suggesting the next time a fat change is needed.

Here I'll be demonstrating the reset on a 2003 Toyota 4Runner, and although the precise steps vary from make to make, the essential procedure is similar. Some makes and models have different procedures, like late-model Dodges, which require three quick presses of the gas pedal to reset. In the event that you try the task shown here and your light doesn't reset, look at your owner's manual, or check online for help regarding your particular vehicle.

Get the Reset Button and Turn On Vehicle System

Search your vehicle's gauge and dashboard area for a button, switch or stick the says "Reset."
Turn the ignition to the ON position so your gauges and electronics illuminate, but don't start the engine.

Set Odometer to Display Mileage

Cycle through different odometer modes until it shows total mileage driven.
Turn the ignition OFF.
Support the Reset Button and Turn the Key

Press and support the reset button.
Turn the ignition back once again to the ON position while holding the reset button.
Watch the oil change or maintenance light carefully. It should start to blink.
Enable the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.

Start the Vehicle

Start the engine and make the sure the oil change or maintenance light is currently OFF.
If it's still ON, repeat the reset procedure.
If the dashboard light remains ON after two tries, make reference to your owner's manual or the automobile manufacturer's site to learn more about the procedure for your vehicle.

Click Here to obtain additional information about check engine light.

Report this page